Generation lighting

Installation Instructions for
Garrett Wall
7
Temporarily install the mounting plate to the junction box.
Mark the anchor locations through the holes on the mounting plate, then remove the mounting plate from the junction box.
Drill appropriate sized holes at the marked points and install the anchors.
Secure the mounting plate to the junction box and screw the anchors screws into the anchors.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut. Connect the black fixture wire to the hot power line wire with a wire nut.
Properly place all wires and wire nut connections into the junction box/fixture base, mount the fixture onto the mounting plate, and secure it in place using the fixture screws.
9 Screw the lamps into the sockets. Refer to the label on the socket for Max Wattage Information.
Align the shade holes with the fixture holes and secure the shade in place by screwing in the thumb screws beginning with the side screws. NOTE: Side screws must be installed first, then the center screws for proper installation.
1
1.1
CW1002
CW1002
1A
Wall
GENERAL PRODUCT INFORMATION:
CAUTION - RISK OF FIRE
This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
Use minimum 90°c supply conductors.
These fixtures are intended to be installed utilizing NEC compliant junction boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer. LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer for additional information.
8
10
JUNCTION BOX
THUMB SCREW (see note)
3
3
MOUNTING PLATE
4
6
8
7
FIXTURE SCREW
8
SHADE
ANCHOR
ANCHOR SCREW
3