Overall outline of equipment

Rotating dual station
Forming manipulator
Material receivingbox
Forming and picking station
Discharge station
Positioning fixture (stainless steel)

Equipment process flow chart
1
Manually insert the product into the positioning fixture
2
Start double button, dial rotate 180 degrees
3
Forming manipulator movement, the needle bending angle, hot hair dryer will start the needle shaped
4
After forming, the manipulator takes the needle tube into the material box
After forming, the manipulator takes the needle tube into the material box
5
Turntable rotating 180 degrees to the manual discharge station
Cycle time ：17s（Bending 6s+hot blow forming 8s+unloading 3s）
Single product time ：2.8s/pcs
Single equipment capacity： 3600s/2.8s=1285pcs/h

Heating cylinder
Splint
Rotating disk
Positioning jig
Slide cylinder
Translation cylinder
Bending cylinder
Hot tip
Receiving box
The needle tube is rotated to the forming station, and the cylinder motion splint is moved to the needle tube
Clamp the needle tube bending, heating cylinder down, hot wind near the elbow, hot blow points start, needle shaped
After the needle tube is formed, the slide cylinder is lifted, the needle tube is lifted out of the jig, and the translational cylinder is retracted to the top of the receiving box
Needle tube forming and blanking

Equipment dimensions